How To Clean A Hayward Salt Water Pool Cell

How to clean your hayward salt chlorinator turbo cell.

How to clean a hayward salt water pool cell. With the generator cell secured to the cleaning stand pour the diluted muriatic acid in through the top. Point it in one end of the unit letting the water go through it and flow out the other end. Step 1 turn off your pool pump unplug the chlorine generator unplug the salt cell from the chlorine generator and turn off all the necessary valves. Step 2 next relieve the water pressure in the pool line.

Salt only leaves the pool from backwashing a filter splash out leak or removing water from the pool. You can start cleaning the salt cell with a standard garden hose. Wear safety gloves and pour 1 gallon of muriatic acid into the bucket carefully. Here is how to recalibrate a hayward aqua rite turbo cell in three simple steps.

If there is no buildup it s time to re calibrate the cell. The first thing to do is to remove the cell and check the blades inside for buildup. Ideally this should be done at the circuit breaker. This process should help remove random bits that have gotten caught in there as well as some of the mineral deposits.

How to clean salt cells with muriatic acid. Try a hose first. Using rubber gloves and safety goggles for protection add one quart of muriatic acid to one gallon of water add acid to water not water to acid in a clean plastic bucket. Once removed look through the cell and inspect for scale formation light colored crusty or flaky deposits on the plates.

Turn off the power to the system and deactivate the pool pump before removing the turbo cell. If there is buildup follow the procedure for cleaning the cell outlined in how to maintain and extend the life of your salt cell. Work in a well ventilated area and do not inhale the fumes. Holding the salt cell by the power cord or top portion of the cell slowly lower it into the bucket.

Step 2 grip the right side collar of the salt cell with a pair of water pump pliers and loosen it by rotating it towards yourself until hand tight. Reset aquarite salt chlorination inspect cell light if the inspect cell light is the only led light flashing then you can reset it by simply holding down the diagnostic button for 3 seconds then release. Your first step in cleaning the hayward aquarite turbo cell is to turn off the power to the pump and chlorine salt generator.